Виды накопителей кодов Toyota/Lexus

Модераторы: mek, indy

Ответить
Сообщение
Автор
Аватара пользователя
vasaby
Сообщения: 2171
Зарегистрирован: 29 июл 2005, 05:08
Откуда: Санкт-Петербург

Виды накопителей кодов Toyota/Lexus

#1 Сообщение vasaby » 24 янв 2009, 14:13

Current DTC
Current DTC’s are trouble codes that are stored in the ECU when
both continuous and non-continuous (2 trip) monitors fail.
Current DTC’s command the MIL On the instant they are stored in the ECU.
Current DTC’s can be cleared using the Clear DTC’s function of the Scantool,
or when the ECU monitor (2 trip monitor) has ran and completed 40 consecutive
trips without a fault.

Pending DTC
Pending DTC’s are trouble codes stored in the ECU when
non-continuous (2 trip) monitors fail the first trip.
Pending DTC’s do not command the MIL On when stored in the ECU.
Pending DTC’s remain stored in the ECU until the ECU monitor completes and Passes one trip.
If the monitor fails the 2nd trip, the Pending DTC remains, a Current DTC is set,
and the MIL is turned on. Pending DTC’s can also be cleared using the Clear DTC’s
function of the Scantool.

History DTC
History DTC’s are trouble codes stored in the ECU when
continuous and non-continuous monitors (2nd trip) fail.
History DTC’s set in conjunction with Current DTC’s and are not cleared by the ECU monitor.
History DTC’s can only be cleared using the Clear DTC function of the Scantool.

Permanent DTC
Permanent DTC’s are trouble codes that are stored in the ECU when
continuous and non-continuous monitors fail. Permanent DTC’s are set in conjunction
with Current and History DTC’s. Permanent DTC’s can not be cleared using the
Clear DTC’s function on the Scantool. Instead, Permanent DTC’s are cleared when
the ECU monitor completes and passes three consecutive trips.
Вложения
1.png

alflash

Permanent DTC’s

#2 Сообщение alflash » 03 апр 2009, 17:48

vasaby писал(а):Permanent DTC
Permanent DTC’s are trouble codes that are stored in the ECU when continuous and non-continuous monitors fail. Permanent DTC’s are set in conjunction
with Current and History DTC’s. Permanent DTC’s can not be cleared using the Clear DTC’s function on the Scantool. Instead, Permanent DTC’s are cleared when the ECU monitor completes and passes three consecutive trips.
Вы как всегда внимательны! ;)
Позволю добавить
Относительно новая и особая категория кодов со статусом "Permanent DTC". Такие коды записываются в память, если выполнение какого-то монитора закончилось с результатом "FAIL", то есть обнаружением неисправности. Эти коды не могут быть "стерты" сканером. Другими словами, только компьютер может стереть такой код после запуска и выполнения соответствующего монитора (в течение трех поездок) с результатом "PASS", т.е. при условии устранения неисправности и и соответствующей само(пере)проверки этого "факта".
Начиная с автомобилей 2010 модельного года, код любой неисправности, который вызывает включение индикатора MIL, должен регистрироваться как Permanent DTC. Он (и) обязательно сохраняется в энергонезависимой памяти (NVRAM) и его (их) "стирание" защищено от отключения аккумулятора и любых команд диагностических сканеров. Рассмотренные требования таких кодов вводится постепенно в течение 2010-2012 г. (50/75/100%).
Чтение этих кодов доступно во вновь вводимом режиме сканеров – Mode #0A . ECM обязан сохранять не менее четырех таких кодов. Кроме этого, для кодов относящихся к пропускам воспламенения и к топливной системе в энергонезависимой памяти должны сохраняться значения «аналогичного состояния» (similar conditions), т.е. данные при которых они (коды) определены.

alflash

p.s. Виды накопителей кодов Toyota/Lexus

#3 Сообщение alflash » 14 янв 2010, 19:51

В http://alflash.com.ua/avtovideo/perm/index.php - небольшая иллюстрация и дополнения к этой теме
HTH,

Ответить